How to Remove Fish Tank Stains: Hard Water, Algae, Tannins

9 min read

The short answer

White crust near the waterline is typically limescale from evaporating hard water. The Spruce Pets, a pet magazine, moves fish out, drains the tank, soaks the glass in white vinegar, then scrapes glass only. With fish in, it keeps home cleaning products out. On acrylic: no razor, and an acrylic builder advises against vinegar.

These steps cover glass and acrylic freshwater tanks. Spruce says the residues “won’t hurt your fish or your aquarium”. Tinted water is a separate problem: see why aquarium water turns brown.

Which stain is it?

SymptomCause, per the source
White crust or streaks near the topHard water evaporating, leaving “limescale” (Spruce)
Hard green spots that won’t wipe offGreen spot algae (Aquarium Co-Op)
Yellow-brown tintTannins from wood or leaves (Fishkeeper)

What you need

  • Plain white vinegar, for glass. Not for acrylic: Titan Aquatic Exhibits, an acrylic aquarium builder, says “It’s recommended not to use vinegar, bleach, ammonia, or alcohol-based cleaners because they could damage the acrylic or harm the aquatic life.”
  • A non-abrasive pad or cloth (Spruce), and tools never used with soap. Aqueon, an aquarium equipment maker: “Don’t use buckets, scrub pads or any other equipment on your aquarium that have been used with soap or other chemicals.”
  • Gloves. The CDC: “Wear gloves when cleaning or caring for your aquarium, especially if you have cuts or wounds on your hands or if you plan to work with rough rocks or spiny fish.” Also: “People with weakened immune systems should let others in the household care for the fish tank when possible. If this isn’t possible, they should wear gloves.” and “Don’t let children younger than 5 years old clean or handle aquarium items.”
  • A scraper made for your tank’s material. Both below are picks in our fish tank cleaner roundup; the API scraper is also compared in our algae scraper roundup. API, a maker, says of its pad: “For glass aquariums only. Do not use on acrylic, Plexiglas, or any surface other than glass.” Continuum, a maker, calls its plastic blade “softer than acrylic, so it will not scratch acrylic*”, with a caveat in step 5.

Removing limescale from an empty tank, step by step

This is The Spruce Pets’ method, with each maker’s caution in the step it guards. Aqueon’s general cleaning rule, not about stains, says “Don’t completely tear down your aquarium to clean it. This will destroy the biological balance with disastrous results.”; Spruce’s stain method drains the tank completely. No source here settles it.

Unplug everything before your hands go in

Hydor, a heater maker, in its Theo manual: “Warning: disconnect all the appliances in the aquarium or bowl before carrying out any installation or maintenance work.” On the heater’s wait before you drain, the manual says “at least 5 minutes” and Hydor’s support page “at least 30 minutes”; with no manual for your heater, our reading is the longer wait. The manual adds: “Do not connect the heater to the power supply when it is not submerged in water.”

Move the fish out, then empty the tank

Spruce’s method has you “relocate your fish to a holding tank”, then “drain the tank completely of water and remove any plants or decorations.” The CDC: “Dump tank water and clean aquarium items in a bathtub, laundry sink, or outside instead of a kitchen sink when possible.”

Soak the crust in vinegar, on glass only

Spruce: “Lay the tank down on a towel, and pour enough vinegar on the affected glass to cover it. Let it sit for 10 to 20 minutes, then scrub with a non-abrasive pad or cloth.” Owners on r/Aquariums, a forum, differ: one leaves vinegar-soaked paper towels on the glass (“Let them soak for a few hours.”), another says “Let sit for 10min and wipe. Repeat for thicker stains.” The thread’s starter, on a second-hand tank, “tried the vinegar and nothing”. No vinegar on acrylic (Titan, above).

Scrape what is left, on glass panels only

Spruce: “If you have a stubborn patch of build-up, try using a razor blade or algae scraper to gently scrape the scale away from only glass panels.” and “Be careful not to damage the silicone glue holding the glass panes together.” Green Aqua, an aquascaping retailer: “The algae scraper should not be used in the aquarium corners, as the silicone bonding could be damaged. Therefore, the best practice is to keep a small safety distance of about 0.5cm from the corners.” (About 0.2 inch; our conversion.) It adds that “it is also highly advisable to keep the algae scraper out of the reach of children.” API, on its glass pad: “Do not use on dry surfaces.” Spruce’s method scrapes a drained tank; API says its pad is not for dry surfaces; this page does not settle that.

On acrylic, put the razor away

Spruce: “Do not use a razor on plexiglass or other types of acrylic tanks as any sharp tools will easily scratch them.” Titan: “Avoid using abrasive materials”. Continuum says a user “should test blade in an inconspicuous area prior to use to insure compatibility”. For a cleaner spray, follow its label; our glass cleaner roundup quotes one spray’s label.

Rinse, refill with treated water, then power back up

Spruce: “Once you’re done, rinse the tank thoroughly before refilling.” For a freshwater tank, Aqueon says to “add water conditioner to new water and then refill the aquarium. Be sure to match temperatures of the new water with the aquarium.” Hydor: “The Heater can ONLY then be turned back on when the Aquarium is full and the heater is completely submerged.” The CDC: “Clean and disinfect sinks and bathtubs after using them to dump aquarium water or clean aquarium items.”

If fish look unwell afterward, test the water and contact an aquatic veterinarian; our guide to lowering ammonia covers high readings.

With fish in the tank

Spruce: “Lime buildup looks so terrible that there can be a great temptation to use home cleaning products to remove it. However, resist that urge, as even the smallest drop or leftover residue from any cleaning agent will likely be lethal to your fish. This rule goes for the top edges of the tank as well.” The same article says “Check your local pet store for fish-safe cleaning sprays”, and moves the fish out before its vinegar method; this page gives no spray steps for a tank with fish in. Fritz Aquatics, a water-care maker that sells its own glass cleaner: “Most household glass cleaners contain ammonia or other harsh chemicals that are toxic to fish, reptiles and invertebrates.”

No source here gives a limescale method for a tank with fish in. Green Aqua describes algae scrapers with a “sharp stainless-steel blade” that “can even make firmly attached lime deposits disappear”; Spruce limits a razor or scraper to “only glass panels”, and Green Aqua’s corner caution (step 4) applies. Our glass cleaning guide covers scraping a stocked tank and siphoning out what comes loose.

Magic Eraser and melamine pads

Seachem, a water-care maker, calls its melamine pad “Safe for Glass and Acrylic” and “chemically inert and does not use soaps or detergents”, and says melamine “performs on stains a lot like extremely fine sandpaper”. Titan, for acrylic: “Avoid using abrasive materials”. Titan does not name melamine. Owners on r/Aquariums split: “Magic eraser is essentially super fine sandpaper, I wouldn’t suggest using it on glass.”; “Scratches plastic”; “magic eraser is fine on acrylic aquariums”; another wants one “without any detergent”. No eraser maker is quoted here.

Algae spots and tannins

Algae spots. Aquarium Co-Op, an aquarium retailer, describes green spot algae as “tiny, hard green spots” that are “very difficult to clean off.” Its fix: “Try using a razor blade (for glass tanks) or gift card (for acrylic tanks) to remove the algae from aquarium walls.” (See step 5 for Spruce’s and Titan’s acrylic cautions.) Causes are in our algae guide.

Tannins. Fishkeeper, the site of UK aquarium retailer Maidenhead Aquatics, says wood “can be soaked first for a long duration before being added to the aquarium”, “small pieces can be boiled to speed up the process” or “activated carbon can be added to the filtration to supplement a regime of water changes to dilute the staining.” That treats the water. No source here gives a way to lighten silicone seams that have taken the tint; Green Aqua cleans seams with a soft brush so that “the dirt in these areas can be removed without damaging the silicone bonding in the corners.”

Keeping lime lines from coming back

Spruce says to “check your tank’s water line every two or three days”, and “the best replacement for evaporated hard water is distilled water, if you are only topping off the tank and not doing a water change.” Its reason: “Replacing evaporated water with additional mineral-rich water can slowly lead to a lethally high level of some minerals.” For water changes it says to “use your regular hard water source to fill the aquarium after removing some of the old water.” It adds: “A water test kit that measures pH, hardness (GH), and alkalinity (KH) is good to have to make sure your water quality is safe for your fish.” Our freshwater test kit roundup compares kits.

What not to do

  • No home cleaning products in a tank with fish, top edges included (Spruce); no household glass cleaners (Fritz).
  • On acrylic: no razor (Spruce), no vinegar or abrasive materials (Titan), no glass-only pad (API).
  • No blade in the corners’ silicone (Spruce, Green Aqua), and no API glass pad on dry glass.
  • No heater powered out of water (Hydor).

Where your tank’s, scraper’s or cleaner’s maker prints instructions, follow them over these general steps.

Ready to buy?

Our fish tank cleaner roundup compares siphons, magnets and scrapers; our bio filter media roundup compares filter media by type; our Water Problems section has more water and stain guides.

Frequently Asked Questions

Q. What cleans calcium off a fish tank?

In Spruce’s method, plain white vinegar on a drained glass tank, then a razor blade or algae scraper on glass panels only.

Q. Can I use CLR on a fish tank?

No maker or publication cited here approves it, and Spruce warns against home cleaning products. Owners on r/Aquariums differ: an owner describing the same second-hand tank says CLR “got alright results but not perfect”; another warns “It can soak into silicone caulking and leech out later to poison animals”. This page did not check CLR’s maker on aquarium use.

Q. Can hard water stains be permanent on glass?

Owners on r/Aquariums disagree. One: “Unfortunately this may be etching on the glass due to hard water buildup. If so, it’s extremely difficult to remove.” Another: “Hard water buildup would be the opposite, a residue that has been added onto the surface.”

Q. How do I clean hard water stains on a fish tank lid?

No source here gives lid steps; Spruce’s rule “goes for the top edges of the tank as well.”

Sources (13)

Product prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on Amazon.com at the time of purchase will apply to the purchase of this product.

Aquarium Tales Team
Aquarium Tales Team

Written and reviewed by the Aquarium Tales Team. See the About page for how we work.