How to Keep Aquarium Plants Alive: 7 Things to Get Right

10 min read

The short answer

Give plants steady light on a timer (the sources here range from 5 to 12 hours a day), feed root feeders through the substrate and leaf feeders through the water, keep Anubias nana and java fern rhizomes uncovered, expect new plants to melt, trim a part at a time, and start with species a grower rates easy.

These steps are for freshwater tanks; each figure names its source.

What you need

  • A light on a timer, fertilizer, substrate, wood or stone with fishing line, and sharp scissors.
  • Unplug the tank’s devices before your hands go in the water (Zoo Med’s heater rule in step 2, applied to every device: our reading).

Only Aqueon’s guide names one of these products, its own plant food, and Aqueon sells it; no source here names the other two. Seachem Flourite Black is a gravel Seachem says “need not be replaced”, per our planted substrate roundup. Aqueon Plant Food is a weekly liquid in our plant fertilizer roundup; go by your bottle’s label. AQQA AQ213 is for 32- to 40-inch tanks; our planted aquarium light roundup lists “timer lengths of 3, 6, 8, 10, 12 and 14 hours” from its manual and notes AQQA publishes no PAR (also in our fish-color lighting roundup).

  1. Light: how strong and how long

SourceHours a dayIts note
The 2Hr Aquarist (fertilizer maker and shop)5 to 9New tanks: 5 to 6
API (maker)8 to 10“to prevent algae growth”
Dennerle (maker)8 to 1210 “proved to be a good idea”
PetSmart (retailer)8 to 12None given
Aqueon (maker)10 to 12None given

Put the light on a timer and keep the hours the same every day

Dennerle, a German aquarium-products maker, recommends one (“A timer is recommended for this.”). Sources split on a midday break. Dennerle: “Our recommendation: 5 hours light – 2 hours dark – 5 hours light.” The 2Hr Aquarist: “A “siesta” (light off in the middle of the day) is not useful; pick a single window.”

Start a new tank on shorter days

The 2Hr Aquarist: “New tank (first 4 to 6 weeks): 5 to 6 hours, increasing gradually as plants establish.” Dennerle starts higher: “We recommend gradually increasing the lighting time from 8 to 10 hours/day during the start-up phase, i.e. within the first 4 – 5 weeks.”

Hours do not make up for weak light: match strength to your plants

Aqueon, an aquarium-products maker: “Leaving the light on longer will not compensate for weak lighting.” The 2Hr Aquarist measures PAR at the substrate: “Low light plants: 10 to 30 µmols at substrate level.” and “Medium light plants: 40-90umols at substrate level.” On watts they split: API recommends “2-4 watts of light per gallon of aquarium volume” for most plants; Aqueon writes that High Output T5 and LED lighting are “making “watts per gallon” no longer valid”.

  1. Feed roots and leaves

Dennerle: “Plants always absorb nutrients via roots and leaves. Species with a strong root system prefer the roots, those with fewer roots but a large leaf surface prefer the leaves.”

Feed heavy root feeders through the substrate

Unplug first. Zoo Med, an aquarium-products maker, in its heater instructions: “Unplug before placing your hand(s) in the water of the habitat. Be sure that your hands are completely dry before plugging the heater into an appropriate electrical outlet.” We apply that to every plug-in device in the tank (our reading). Aquarium Co-Op, an aquarium shop that sells its own fertilizer line, says heavy root feeders “such as sword plants, cryptocoryne plants, and bulb plants — prefer feeding from the ground” (see our Amazon sword guide), and adds root tabs when you use “a cheap, inert substrate like regular aquarium gravel or if your aquarium soil has run out of nutrients over time”. No other source read gives a start-up schedule for tabs (Dennerle’s first-week pause is item 3). Place tabs by your product’s label, cautions included. Aqueon: “Do not use plant tabs or fertilizer sticks intended for houseplants as they may not have the correct balance of nutrients for aquatic plants.”

Feed leaf feeders and stems through the water

Dennerle: “Fast-growing stem plants in particular draw large amounts of nutrients from the water.” Co-Op adds that heavy root feeders “still take some nutrients from the water column”. Dose by your bottle’s label; see how often to fertilize aquarium plants.

Go easy on new plants (Dennerle)

For newly set up tanks, as plants “still have nutrient reserves from the greenhouse”: “they should not be fertilized in the first week and only half the dose recommended on the packet in the second week.”

  1. CO2: low-tech or injected

The sources split. Aqueon: “Most aquatic plants don’t require additional CO2 to grow, but their size, color and vibrancy are always better when it is added.” The 2Hr Aquarist: “Most aquarists are better off having CO2 at optimal levels for plant growth, whether low or high light is used.” Tropica, an aquarium-plant grower and seller (Tropica Aquarium Plants A/S), lists “CO2: Low” for the four plants in step 7; no source read says what that rating means for a tank without injection.

With injection, set it up by your system’s manual and raise it slowly

The 2Hr Aquarist lists the parts as “cylinder, regulator, bubble counter, tubing, diffuser or reactor, and a timer”, and warns: “CO2 adjustments should be made gradually to avoid hurting fish.” See adding CO2 to an aquarium.

  1. Substrate and planting

Use a substrate that suits rooted plants

Aqueon: “Fine to medium grade gravel or coarse sand are best”, laid as “a 2” to 3” base” (5 to 8 cm, our conversion), and “Always rinse substrate before placing it in your aquarium.” It says to avoid “dolomite, crushed coral, crushed oyster shells or other calcium carbonate-based substrates, as they will cause an undesirable rise in pH and alkalinity.” Sources differ on plain gravel. Dennerle, which sells a nutrient substrate: “Gravel alone is not enough because it doesn’t contain any nutrients.” Co-Op adds root tabs to inert gravel instead (step 2), and warns that nutrient-rich soils “can come with side effects like lowering the pH or leaching ammonia into the water (which is toxic to fish)”. Dennerle: “Soil wears out like a battery. It should be replaced every 1 – 2 years. It is also not suitable for bottom-dwelling fish such as armored catfish, as they constantly stir up the substrate, which leads to cloudy water.”

Keep the rhizome of Anubias nana and java fern uncovered

Tropica, for Anubias barteri var. nana: “The best result is achieved by planting on a stone or tree root. Fishing line can be used to attach the plant until it gains a hold. If planted on the bottom the rhizome must not be covered because it tends to rot.” For Microsorum pteropus, which Aquarium Co-Op calls “Java Fern (Microsorum pteropus)”, Tropica: “If planted in the bottom, do not cover the rhizome because it will rot.” See our anubias, java fern and planting method guides.

  1. Expect melt in new plants

Co-Op’s plant FAQ: “It is normal for plants to “melt” when they change environment.” One cause it names is “a plant converting from emersed (grown out of water) to submerged (growing under water)”.

Remove leaves that are clearly melting

Co-Op, of crypts: “If you see a leaf is clearly melting, cut it off at the base of the stem near the substrate. Rotting leaves can sometimes cause nitrogen spikes or algae growth, so it’s best to remove them unless your clean-up crew members consume the dead leaf first.” Bag the leaves for the trash (our reading of the ANSTF line in step 6).

Give a melted crypt time

Co-Op: “Do not immediately throw away a melted crypt, but rather wait at least three to four weeks to see if the plant will recover and send out new shoots.” Its condition: “As long as it has healthy roots and is not moved once planted, you should see little shoots popping up within a few weeks.” Sources give different cutting advice at different moments. Dennerle, at planting: “With Cryptocorynes, cut off all the leaves.” Co-Op, for a crypt already melting: “you can either prune the leaves one by one as they melt, or you can trim all the leaves back to the substrate”.

Watch for algae while plants melt

Co-Op warns the tank “is more prone to an algae bloom because the crypts are no longer consuming as many nutrients in the water”, and suggests “adding some fast-growing stem plants and floating plants”.

  1. Algae, trimming and dosing balance

Plant densely, with fast growers (Dennerle)

Dennerle: “Our recommendation: when setting up a new aquarium, plant approx. 70 – 80% of the bottom area, half of which should be fast-growing species.” If algae appear after fast growers are later swapped for slow ones, Dennerle says “this is a sign of insufficient competition for nutrients from the plants.” API: live plants “compete with algae for nutrients”.

Trim a part at a time

Dennerle: “If the plants are growing well, pruning is necessary approx. every 4 – 6 weeks.” “Stem plants should be cut back to 10 – 15 cm.” (about 4 to 6 in, our conversion). “It is advisable never to cut back all the plants at once, but only a part at a time.” The Aquatic Nuisance Species Task Force, a federal task force whose classroom guidelines are hosted on fws.gov, wrote for classrooms (using it for trimmings is our reading): “Dispose of unwanted plants in a sealed plastic bag in the trash. These materials should not be composted because their seeds and other plant parts may spread.” It lists giving unwanted plants a new home first, says “Disposal of live organisms should be considered as the last resort.” and notes that “releases are illegal in most states” (PDF read 2026-11-16).

Change the fertilizer dose when light or planting changes

Dennerle recommends “needs-based fertilization, i.e. only as many nutrients are added as are actually consumed in the period in question.” Stay within your product’s label.

  1. Start with easy species

Tropica rates all four plants below “Easy”. Its product pages give these fields (Light demand, CO2, Growth rate):

Plant (Tropica’s name)Light need / CO2Growth rate
Microsorum pteropusLow / LowSlow
Anubias barteri var. nanaLow / LowSlow
Cryptocoryne wendtii ‘Green’Low / LowMedium
Echinodorus grisebachii ‘Bleherae’Low / LowFast

Our beginner plants guide compares more easy species.

Mistakes and when to get help

Common mistakes: buried rhizomes, long hours under a weak light, binning a melting crypt early, cutting everything back at once, houseplant tabs. If plants keep declining, see why aquarium plants die. If fish look unwell after a change to light, CO2 or fertilizer, test the water and contact an aquatic veterinarian.

Ready to buy?

Our Substrate, Plants & Decor section gathers plants, substrates and planted-tank gear.

Frequently Asked Questions

Q. How do I keep aquarium plants alive before planting?

Dennerle says potted and bunched plants should be taken out of their growing medium and soaked “in a bucket of fresh, temperate (approx. 20 °C) tap water 24 hours before planting to remove unwanted substances” (20 °C is 68 °F, our conversion), in “a bright window, but not in direct sunlight”, and that “The water should be changed several times to be on the safe side.” For shrimp tanks it advises “3 days in advance”.

Q. How do I keep aquarium plants from floating?

Dennerle: “Press the plants deep into the soil and then pull them up again slightly so that the roots are pointing downwards.” See our guide to anchoring aquarium plants.

Q. What water temperature do aquarium plants need?

Dennerle gives “20 – 28 °C” (68 to 82 °F, our conversion) for most plants; Aqueon says “between 74° and 80° F.”

Q. Do aquarium plants need water flow?

Dennerle wants “a constant but rather slow water movement”, filtering the tank “approx. 1 – 2 times per hour”.

Sources (9)

Product prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on Amazon.com at the time of purchase will apply to the purchase of this product.

Aquarium Tales Team
Aquarium Tales Team

Written and reviewed by the Aquarium Tales Team. See the About page for how we work.